CrossXfire CFH10 - Choosing the Mounting Location in a Room; Mounting Restrictions and Room Coverage; Applying the Self-Adhesive Warning Label; Cleaning Your Alarm

16
Applying the Self-Adhesive Warning Label
This Heat alarm was shipped with a self-adhesive
Warning Label.
Place the label in the general area near the alarm,
on an adjacent door, or the equivalent. This label
contains information on the capabilities and some
limitations of heat alarms.
WARNING
Cleaning Your Alarm
Over time, dust might collect on the surface of your Heat alarm. To clean the
alarm perform the following:
Remove the alarm from its bracket.
Vacuum all the external surfaces carefully. Wipe
with a clean, dry cloth. Do not use cleaners or
solvents.
Do not submerge the Heat alarm in water.
The sensitive electronics will be damaged!
Press and release the Test button on the front
face to verify the alarm is still functioning prop-
erly and reinstall on the wall/ceiling.
Choosing the Mounting Location in a Room
NO!
Do not install between joists or rafters.
OK
Install on exposed face of joist or rafter.
Room Coverage Area
The Heat Alarm has a space rating of 50’ (15.2m)
This will cover a room of 35’ x 35’ (10.7m x 10.7m)
35’ (11.7m)
35’ (11.7m)
General Note: Do not install within 36” (91cm)
of heating/cooling vents, or where drapes or
furniture impede air flow.