Crowcon Gas-Pro - Quick Start Guide Manual

H
2
S
CO
CH
4
Gas-Pro
Quick Start Guide
Gas-Pro
Multi-Gas Confined Space Monitor
M07998/Eng
Issue 2 Jan 2015
IN USE
+ve Safety™
+ve Safety™ (Positive Safety) provides
positive conrmation of detector status prior
to deployment in the eld or on return from
site. The front mount tri-colour LED gives
the Safety Manager or Supervisor unrivalled
visibility of the status of the Operator’s
detector.
Charging
• To charge, insert the charger connected into the socket at the back of
the Gas-Pro.
• The display will show the battery lling and RED LED’s will ash red
until the battery is full, when they will ash green.
Gas Testing
Crowcon recommends regular gas tests (also known as bump tests) to
conrm sensor operation. A number of exible and simple solutions are
available:
Q-Test Quick and simple in-led gas test and calibration solution.
I-Test Intelligent wall or desk mount, powered data management
solution.
S-Test Service and maintenance solution for up to 5 detectors.
If congured to do so, test and calibration can also be completed manually
by using the non-pumped ow plate and following prompts on the screen. If
a test should fail or calibration is due and the Gas-Pro has been manually
zeroed in the last 15 minutes a calibration can also be completed.
See the Gas-Pro User and Operator manual for details.
Safety Information
•
warnings and label information.
•
•
hazardous (safe) areas.
•
+55°C (-4 to 131°F).
Certication Information
IECEx:
IECEx ULD 11.0004X
ATEX:
DEMKO 11 ATEX 1031772X
UL:
5
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30