26
Accessories and spares Triple Plus+ and Triple Plus+ IR
0– 100 ppm nitric oxide S01245
0– 25% vol oxygen S011371
0– 10ppm hydrogen chloride* S01724
0– 25ppm hydrogen cyanide S01725
0– 50ppm ammonia S01726
0– 2000ppm hydrogen S01250
0– 2ppm phosphine S01252
0– 100ppm volatile organics** S011367
0– 10ppm ethylene oxide S011366
0– 10ppm hydrogen fluoride S01832
Triple Plus+ IR only
Sensor assemblies:
Sensor Module Methane 0–100% LEL (UK) S011316/U
Sensor Module Methane 0–100% LEL (ATEX) S011316/A
Sensor Module Methane Dual Range 0–100% LEL & 0–100% Volume (ATEX) S011317/A
Sensor Module Propane 0–100% LEL S011318
Sensor Module Propane Dual Range 0–100% LEL & 0–100% Volume S011319
Sensor Module Butane 0–100% LEL S011320
Sensor Module Butane Dual Range 0–100% LEL & 0–100% Volume S011321
Sensor Module Ethylene 0–100% LEL S011322
Sensor Module Ethylene Dual Range 0–100% LEL & 0–100% Volume S011323
Sensor Module Acetylene 0-100% LEL S011790
Sensor Module Acetylene Dual Range 0-100% LEL & 0-100% Volume S011792
Triple Plus+ IR Membrane Switch Assembly E01823
Note: IR sensors should not be fitted in and will not be recognised by standard Triple Plus+
units.
For additional spares please contact Crowcon
*Readily absorbed gases – they will not be detected if an aspirator or hose are used and are
unsuitable for use in pumped instruments.
**This broad range sensor has a high level of cross sensitivity and it can be used to monitor
many gases.
For additional spares please contact Crowcon
To Next Page
Loading...
