Page 31 of 64
5. Attach the side burner gas hose to the “Tee”
(See “Figure 13” for further details).
Make sure the hoses do not come into contact with any hot surfaces, and are routed
outside of the rear leg(s). Adjust the orientation of the "Tee" and the regulator as
necessary.
6. Install the burner rings, grates and protective cover.
7. Finally, before operating the side burner, perform a leak check by brushing on a soap
and water solution at every joint and watch for growing bubbles that indicate a leak.
Once you are confident there are no leaks, you may operate your new Crown Verity side
burner
FIGURE 13. GAS CONNECTION FOR SB-MCB CABINET
To Next Page
Loading...
