DriveCore Install Network Series Power Amplifiers
page 23
Operation Manual
Set-up and System Conguration
Low-Z (8Ω, 4Ω or 2Ω) Output Operation
Typical input and output wiring, along with Audio Architect
software settings are shown in Figure 19.
INPUTS: Connect the input with wiring in place for each
channel. If the same signal is to drive both outputs of a
channel pair (“mono”), the input signal can be sent to
adjacent amplifier channels. If using the BLU link input, it is
important to understand that BLU link is a digital audio bus
and cannot be routed through a network switch or router.
To increase fault protection, use both the input and output
BLU link wiring connection. For BLU link routing, refer to
page 33.
OUTPUTS: Maintain proper polarity (+/–) on output
connectors. Connect the Channel 1 speaker’s positive (+)
lead to amplifier Channel 1 positive terminal;
repeat for negative (–). Repeat Channel 2 wiring as for
Channel 1, and for any subsequent channel pairs on
multichannel models. Refer to Page 9
for output connector terminal assignments.
Always route the input and output wires in separate bundles.
Figure 19 System Wiring Dual Mode
Figure 20
To Next Page
Loading...
