DriveCore Install Network Series Power Amplifiers
page 25
Operation Manual
Dual Mode Hi-Z (70Vrms/100Vrms) Mode
Typical input and output wiring, along with software
settings are shown in Figure 23. A 35Hz high pass
filter is selected automatically when the amplifier
channel is in Hi-Z or Bridged Hi-Z mode. Remember,
DCi amplifiers allow each channel Hi-Z or Low-Z
mode of operation to be selected independently, while
70Vrms/100Vrms selection is global.
Figure 23 System Wiring for 70Vrms/100Vrms Operation
Figure 24
Always route the input and output wires in separate bundles.
Set-up and System Conguration
Note: 70Vrms/100Vrms is global, while Low-Z/Hi-Z is per output channel
To Next Page
Loading...
