To Next PageTo Next Page
Need help?Do you have a question about the Crown POWER-TECH 2 and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz |
|---|---|
| Input Sensitivity | 1.4V |
| Output Power (4 ohms) | 400W |
| Power Requirements | 120V, 60 Hz |
| THD | <0.1% |
| Output Power (2 ohms) | 600W |
| Frequency Response Tolerance | +0/-1 dB |
| Total Harmonic Distortion | Less than 0.1% |
| Dimensions | 19" x 3.5" |
| Signal to Noise Ratio | >100dB |
| Input Impedance | 20k ohms |
Provides an overview of the warranty terms and conditions.
Lists conditions and situations not covered by the warranty.
Explains how the manufacturer will remedy defects under warranty.
Details the process for requesting warranty service.
States limitations on recovering incidental or consequential damages.
Clarifies that no one can alter the warranty terms.
Outlines legal rights and limitations for warranty claims.
Instructions for unpacking the new amplifier and checking for transit damage.
Highlights key features of the Power-Tech amplifiers.
Steps for connecting and operating the amplifier in stereo mode.
Details for Bridge-Mono and Parallel-Mono operation modes.
How to set the amplifier's input sensitivity for different voltage gains.
Methods to protect loudspeakers using fuses for voltage peaks or heat.
Information on correct AC power cords, plugs, and voltage requirements.
Important safety guidelines for operating the amplifier.
Explanation of the front panel LED indicators (Enable, Signal/IOC).
Overview of internal protection mechanisms like ODEP, RF, and drive protection.
How the transformer's thermal protection works to prevent overheating.
Details on internal fuses and circuit breakers for power supply protection.
Description of front panel and back panel controls like power, level, and mode switches.
Instructions for cleaning the amplifier's air intake dust filter.
Guaranteed minimum output power figures for different models and loads.
Recommended safe load impedance ranges for various operating modes.
AC power requirements, current draw, and voltage specifications.
Details about the internal DC fan power supply.
Information on the provided AC line cord and connector types.
Details on input connectors, impedance, output connectors, and impedance.
Describes the signal characteristics for Stereo, Bridge-Mono, and Parallel-Mono modes.
Details physical build, materials, and cooling system of the amplifier.
Provides rack mount size, physical depth, and net/shipping weights.
Presents minimum guaranteed power output for Power-Tech 1 in various modes and loads.
Presents minimum guaranteed power output for Power-Tech 2 in various modes and loads.
Presents minimum guaranteed power output for Power-Tech 3 in various modes and loads.
Details maximum power output for Power-Tech 1 under single cycle and 40ms burst conditions.
Details maximum power output for Power-Tech 2 under single cycle and 40ms burst conditions.
Details maximum power output for Power-Tech 3 under single cycle and 40ms burst conditions.
Describes the MT-XLR accessory panel for XLR input connectors.
Describes the MT-BB accessory panel for barrier strip input connectors.
How to obtain service from authorized centers globally.
Options for service in North America, including local centers and factory service.
