Need help?Do you have a question about the Crown PS-200 and is the answer not in the manual?
General| Power Output (8 ohms) | 200W |
|---|---|
| Power Output (4 ohms) | 300W |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion (THD) | <0.05% |
| Signal-to-Noise Ratio | >100 dB |
| Input Impedance | 20 kOhms |
| Input Sensitivity | 1.4V |
| Damping Factor | >200 |
Details advanced circuit design, low distortion, bridge-mono capability, passive cooling, and warranty.
Covers frequency response, phase, signal-to-noise ratio, THD, IMD, slew rate, and damping factor.
Specifies output power in stereo/bridge modes, load impedance, and AC mains voltage.
Describes front panel controls, indicators, input/output connectors, and chassis ground.
Outlines materials, dimensions, weight, and rack-mounting specifications.
Delivers minimum 95W into 8 ohms or 135W into 4 ohms per channel.
Capable of 190W into 16 ohms or 280W into 8 ohms when strapped into mono.
Outputs protected against shorts; voltage gain controlled; 1.30V input sensitivity.
Safe with reactive loads; DC-20kHz ±0.1dB frequency response.
Standard rack dimensions, weight, and 50-400Hz AC power options.
Covers repairs or replacement for any reason for three years, including shipping.
Optional extension providing an additional three years of comprehensive warranty coverage.
To Next Page
