Need help?Do you have a question about the Crown PS-400 and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Signal-to-Noise Ratio | >100 dB |
| Type | Stereo Amplifier |
| Total Harmonic Distortion (THD) | 0.05% |
| Input Impedance | 20 kOhms (Balanced), 10k Ohms (Unbalanced) |
| Dimensions | 19" x 3.5" x 12.25" |
| Input Sensitivity | 1.4V |
| Damping Factor | >400 |
Key features including distortion detection, cooling, and warranty details.
Details frequency response, phase, signal-to-noise, THD, IMD, slew rate, and damping factor.
Lists output power ratings for stereo/bridged modes, load impedance, and AC power requirements.
Describes front panel controls, indicators, input/output connectors, and construction.
Details minimum power output for stereo and mono modes, and load handling capabilities.
Describes voltage amplifier slew rate control, RF burnout protection, and load safety.
Specifies voltage gain, input sensitivity, and optional input sensitivity.
Defines hum/noise level and intermodulation distortion specifications.
Covers rack mounting dimensions, weight, and AC power input requirements.
Details the standard warranty covering repairs or replacement for original specifications.
Offers an optional extended warranty for an additional three years.
To Next Page
