Crown PSA-2 - Page 105

SA2PSA2031 280
SA2/PSA2 Intermittant Instability (Addendum)
10000-11343 (PSAZ) 11947-112551 (SA2)
With reference to the RLC output terminating network problem (refer to
Service Bulletin SAZPSA2020780), two components in particular were mentioned
the 2.7 ohm 1Qw resistor and the Juh torriod coil.
If
replacement
of
the
resister
is
in
order
be
sure
the
leads
are
bent
to
provide
optimum
tension
relief
(see
diagram
below).
Lead
lengths
should
be
+
.40 Scale in inches
within given measurements.
‘
2.30
;
|
:
Al) SA2/PSA2 amplifiers after the above serial number group have the
above mentioned modification installed during production.
if you have any further questions concerning this modification, please
feel free ta cal] ar write.
Dow
R.
Cs
fave
R.
Engstrom
Product Specialist