CRT 4CF - SHORTCUT OPERATIONS; CTCSS;DCS Encode and Decode; Cross-Band Repeater

SHORTCUT OPERATIONS
Single-band Switching
CTCSS/DCS encode and decode
To reduce interference from the sub-band when only the main-band is needed. You can use the single-band
switching function to turn off the sub-band quickly.
Continuous pressing of
will cycle LCD display to show Main + Sub-Band / Sub-Band Only / Main-Band
Only.
Press
1.
key then press [PF2] to enter into setup.
Press [PF2] key to choose CTCSS, DCS or OFF, when choose DCS, press
2.
key to select positive
or negative code.
Rotate Channel selector to choose desired CTCSS/DCS encode and decode.
3.
Press
4.
key or key to confirm and exit.
Cross-Band Repeater
Set main-band and sub-band to desired VHF & UHF frequencies, then open cross band repeater function.
In power off radio, press [PF1] and then press
1.
to enter into function menu together and power on
radio until LCD shows "RPT ON". LCD shows "
" in LCD top left corner.
Repeat above operation, "
2.
RPT OFF" is turn off cross band repeater function.
21
MSK