CRT MICRON U/V - Advanced Function Settings; 7.5 Volume level setting; 7.6 Password setting; 7.7 Scan Dwell Time Setup

17
1. Enter FUNCTION MENU list, choose No.05 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
1-36: total 36 levels available
4. Press [PUSH] button or [P3] key to store setting and exit
After enable this function, must be input correct password then can turn on the
transceiver.
1. Enter FUNCTION MENU list, choose No.06 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
ON: Turn on password function.
OFF: Turn off password function
4. Press [PUSH] button or [P3] key to store setting and exit
1. Enter FUNCTION MENU list, choose No.07 function.
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
TO: It pause for preset pause time when scanning a matching signal, then resume
scan.
CO: It pauses once scanning a matching signal, and resume scan when signal
disappears.
SE: It stops once scanning a matching signal.
4. Press [PUSH] button or [P3] key to store setting and exit.
1. Enter FUNCTION MENU list, choose No.08 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
5S : It pauses 5s once scanning a matching signal, then resume scan
10S : It pauses 10s once scanning a matching signal, then resume scan
15S : It pauses 15s once scanning a matching signal, then resume scan
4. Press [PUSH] button or [P3] key to store setting and exit.
When turn off AOP, the radio need press
key to power on when connect with the
power supply.
1. Enter FUNCTION MENU list, choose No.09 function.
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
ON : Enable AOP function
OFF: Power off by manual
4. Press [PUSH] button or [P3] key to store setting and exit.
7.5 Volume level setting
7.6 Password setting
7.7 Scan Dwell Time Setup
7.8 Scan Pause Time Setup
7.9 AOP (Automatic power on setup)