Crumar MOJO - Page 7

7
5. MIDI IN: This five-pole DIN connection is used to connect the CRUMAR Mojo to
a device capable of sending MIDI data, such as a master keyboard or a
pedal board. This connection is also used when updating the instrument’s
firmware with MIDI Firmware Upload (MFU) technology.
PLEASE NOTE: if your organ is a rev.C, Midi in plug is not working if you have a usb
cable plugged in the USB – MIDI PLUG.
6. MIDI OUT: This five-pole DIN connection is used to connect the CRUMAR Mojo
to a device capable of receving MIDI data. The instrument’s controls are
configured as follows:
• Channel 1: Drawbars, pots and all other upper manual controls
• Channel 2: Lower manual
• Channel 3: Lower manual if “Pedal to Lower” function is enabled
CAUTION: It is highly recommended not to connect or disconnect MIDI cables with
the instrument on. The instrument can be damaged or work incorrectly.
7. USB – MIDI PLUG : This connection is used to send and receive MIDI data from
the CRUMAR Mojo to a computer via USB without the need for a converter. For
example, the CRUMAR Mojo could be used to play sounds from a software-
based synthesizer on a laptop computer. Please check software driver
compatibility on the computer before connecting the CRUMAR Mojo. It can be
used for firmware upgrade too (only on mojo rev.C)
8. Swell: This 6.3 mm stereo output jack connection is used to connect an
expression pedal to the CRUMAR Mojo.
Please use only genuine CRUMAR expression pedals. Other pedals and/or
equipment can damage the instrument. For a compatibility list, please contact
CRUMAR MUSICAL INSTRUMENTS.
CAUTION: Do not connect or disconnect the expression pedal with the
instrument on. The instrument can be damaged or work incorrectly.