11
• Control Knobs: These six knobs are used for real-time control over various
parameters of the sound of the instrument.
Volume: Overall output volume of the instrument
Drive: Adjusts the amount of saturation from the tube overdrive emulation
Click: Adjusts the volume of the key-click simulation
Reverb: Adjusts the depth of the spring reverb simulation
Bass: Adjusts the equalization of the output of the bass frequency of the
instrument. When the knob is set in the middle position (12:00), the equalization
is at zero.
Treble: Adjust the equalization of the ouput of the treble frequency of the
instrument. When the knob is set in the middle position (12:00), the equalization
is at zero.
To start up the CRUMAR Mojo, the instrument needs to be powered on .
START-UP PROCEDURE:
1. Connect the audio cables, expression pedal, sustain pedal and rotary speaker
control cables.
2. Connect the power supply to the instrument and to the main AC outlet.
Press the “Power” button to start the boot-up process. The LED on the “Power”
button lights up.
3. The boot-up process continues as evidenced by the steadily lit LEDs across the
Upper and Lower preset sections. During this process, the instrument starts the
internal software and configures the settings of the various connected
accessories. The boot-up procedure lasts about 18 seconds.
4. After 18 seconds, the led sequence will stop and the instrument is ready to play
in manual mode
SHUT-DOWN PROCEDURE:
1. Hold down the “Power” button for four seconds. All of the LEDs turn off when the
instrument powers down. Please note that the instrument is still under voltage
until the power supply is disconnected. If the instrument will not be used for more
than two hours, it is recommended that the power supply be unplugged from the
main AC connection to extend the life of the power supply and please “think
green", don’t waste energy!
5) START-UP AND SHUT-DOWN PROCEDURES
To Next Page
Loading...
