Need help?Do you have a question about the Crunch CR600.4 and is the answer not in the manual?
Standard operation for specific Crunch amp models without modules.
Wiring diagrams for basic stereo and module-assisted stereo modes.
Instructions for bridged and simultaneous stereo/mono operation.
Instructions for mounting and connecting the CEQ31 equalizer.
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 75W x 4 |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | >90 dB |
| THD at Rated Power | <0.05% |
| Damping Factor | >100 |
| Low Pass Crossover Frequency | 50Hz - 250Hz |
| High Pass Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0 - 12dB |
| Bass Boost Frequency | 45Hz |
| RMS Power @ 2 Ohms | 150 Watts x 4 |
| Bridged RMS Power @ 4 Ohms | 300 Watts x 2 |
| Total RMS Power Output | 600 Watts |
| Input Sensitivity | 200mV - 6V |
| Crossover Type | Variable |
To Next Page