Need help?Do you have a question about the Crunch PowerOne P1-1000.2 and is the answer not in the manual?
Explains the importance of proper gauge wiring for power and ground, and connection methods.
Outlines the recommended order for connecting components and safely powering on the system.
Guides on setting High Pass, Low Pass, Bass EQ, and Level controls for optimal sound.
Specific setup instructions for Subsonic, Bass Boost, Low Pass, and Level controls on mono amps.
Diagnosing and resolving amplifier protect mode activation due to short circuits or faults.
Troubleshooting amplifier overheating, low output power, and fuse blowing issues.
Identifying and fixing hiss, electrical interference, and ticking/whining noises in the system.
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 250W x 2 |
| RMS Power at 2 Ohms | 500W x 2 |
| Bridged RMS Power at 4 Ohms | 1000W x 1 |
| Total RMS Power Output | 1000W |
| Signal to Noise Ratio | >90 dB |
| THD at RMS Output | <0.1% |
| Input Sensitivity | 200mV - 6V |
| Crossover Frequency | 50Hz - 250Hz |
| THD | <0.1% |
| Frequency Response | 10Hz - 22 kHz |
| Bass Boost | 0 to +12dB |
| Crossover | Variable |
To Next Page