Need help?Do you have a question about the Crunch P500.2 and is the answer not in the manual?
Explains proper wire gauge selection and secure connections for amplifier power and ground.
Outlines the correct order for connecting all audio system components.
Provides a step-by-step guide for safely powering up the audio system.
Details controls, connections, and specific features for 2-channel PowerZone amplifiers.
Explains features and controls for 4-channel PowerZone amplifiers, noting differences from 2-channel models.
Describes features and controls for mono block PowerZone amplifiers, including subsonic and low pass filters.
Lists maximum output power for all amplifier models at 14.4V.
Details electrical specs like frequency response, damping factor, and THD for all models.
Covers protection circuits, power supply, and output circuit configuration.
Details crossover settings and bass boost for amplifier channels.
Introduces fine-tuning amplifier settings for optimal audio performance.
General| Channels | 2 |
|---|---|
| RMS Power @ 4 Ohms | 125W x 2 |
| RMS Power @ 2 Ohms | 250W x 2 |
| Bridged RMS Power @ 4 Ohms | 500W x 1 |
| Signal to Noise Ratio | >90dB |
| Frequency Response | 20Hz - 20kHz |
| Crossover Type | Variable |
| Bass Boost | 0 - 12 dB |
| Bass Boost Frequency | 45Hz |
| Input Voltage | 14.4V |
| Input Sensitivity | 200mV - 6V |
| Low Pass Filter | Yes |
| High Pass Filter | Yes |
To Next Page