Crusader Challenger 5.7L Catanium CES User Manual

29
L510032-16
ENGINE MAINTENANCE - 11
Transmission Fluid
CAUTION
Crusader Challenger Engines uses marine
transmissions supplied by several manufacturers.
The maintenance requirements can be di󰀨erent
between these manufacturers. It is important that
you refer to the operation and maintenance manual
supplied by the transmission manufacturer before
you attempt to perform maintenance on your own.
If no maintenance manual is available, Crusader
Challenger Engines recommends that you contact
your Certied Dealer service department for any
required maintenance or service instructions.
Figure 11-2 80 Series Transmission Dipstick and
Location
Challenger 80 Series Transmissions
1. The uid level must be checked in one of the
following conditions:
A. Engine/Transmission is cold;
B. Engine/Transmission has been shut o󰀨 for at
least 2 minutes to allow uid to drain back.
2. Remove the dipstick by turning the T-handle
counterclockwise. Wipe the dipstick o󰀨 using a
clean cloth.
3. Re-insert the dipstick to the threads (DO NOT
screw the dipstick in) and remove. Observe the
uid level.
4. The uid level should be at the “FULL” mark. If
low, add the specied uid in small increments
through the dipstick hole in the transmission.
Repeat the checking procedures untill the uid
level is at the “FULL” mark.
5. Replace the dipstick and tighten securely.
WARNING
Do not attempt to remove the transmission dipstick
while the engine is running. Hot transmission uid
could be sprayed from the dipstick hole.
FULL
ADD
30
0455
9
0
01
R
0
4
10
9
7
Dipstick

Crusader Challenger 5.7L Catanium CES Specifications

General

Brand	Crusader
Model	Challenger 5.7L Catanium CES
Category	Engine
Language	English