Crusader Challenger 5.7L Catanium CES User Manual

59
L510032-16
TROUBLESHOOTING - 14
Malfunction Possible Cause Corrective Action
Engine Overheats Loose or worn drive belt(s) Adjust or replace the belts as
necessary.
Collapsed, kinked or leaking Replace the hoses.
hoses.
Transmission/engine oil cooler Remove the water hoses and ush
plugged in opposite direction of the normal
ow.
Faulty thermostat Replace the thermostat.
Sea-water intake valve Open the valve completely.
partially/fully closed.
Restricted sea-water pickup Remove restriction.
Faulty temperature sending unit Test and replace as necessary.
or gauge
Sea-water pump impeller worn or Replace the impeller.
damaged
The following applies to engines Coolant level low in the fresh-water Check the cooling system for leaks.
equipped with Fresh-Water section of the cooling system Rell the system. See Warning
Cooling (FWC) systems. before removing the ll cap.
Heat exchanger passages plugged Clean and ush the exchanger.
with scales and debris
Improper coolant mixture Install the proper coolant mixture
(50% antifreeze - 50% water).
Insu󰀩cient engine temperature Faulty thermostat Replace the thermostat.
Faulty temperature sender Replace the temperature sender.
Engine oil pressure low Faulty oil pressure sending unit Test and replace as necessary.
or gauge
Oil level low Add specied oil. Check the engine
for leaks.
Crankcase overlled causing oil Remove the required amount of oil.
aeration Determine the cause of overlled
condition (improper lling, etc.).
Diluted or improper grade/ Change the oil and lter.
viscosity of oil Determine the cause of dilution.
(insu󰀩cient engine temperature,
excessive idling, etc.)

Crusader Challenger 5.7L Catanium CES Specifications

General

Brand	Crusader
Model	Challenger 5.7L Catanium CES
Category	Engine
Language	English