Crusader Challenger 6.0L Catanium CES - Maintenance Schedule

49
L510032-16
ENGINE MAINTENANCE - 11
MAINTENANCE SCHEDULE (cont’d)
After 1st Every 50 Every 100
Location and Service Check 25 Hrs of Hours of Hours of Once
Daily Operation Operation Operation Each Year
Flame Arrestor and Crankcase Ventilation
System - Clean and inspect X X
Hoses (all) - Inspect for cracks, swelling,
weather checking or other signs of
deterioration X X
Shift and Throttle Cable Linkage - Inspect
and lubricate (A) X
1
X
Fuel Filters - Service or replace O O
Transmission - Change uid (B) and clean
strainer, if equipped O O
‘V’-Drive Transmissions - Change uid (C)
and clean strainer, if equipped O O
Notes:
(X) Denotes service to be performed by the owner/
operator
(O) Denotes service to be performed by an authorized
Crusader Challenger Engines Certied Dealer
(A) Use SAE 30 engine oil
(B) All Challenger - Use Dexron III automatic
transmission uid
(C) All Challenger Power-Plus “V” Drive transmissions
are designed to be ‘Maintenance Free’. Inspect
uid level after the rst 25 hours of use and annually
thereafter. Fluid should only be changed if evidence
of contamination is present. Use Mobiltrans SHC
50 synthetic transmission lubricant. Crusader
Challenger P/N: R190250
(D) Use WD-40 penetration oil or equivalent
1
In fresh-water areas, every 100 hours of operation or
120 days (whichever occurs rst). In salt-water areas,
every 50 hours of operation or 60 days (whichever
occurs rst).
2
In fresh-water areas, every 50 hours of operation or
60 days (whichever occurs rst). In salt-water areas,
every 25 hours of operation or 30 days (whichever
occurs rst).
Crusader Challenger Engines recommends that all
periodical and annual service be performed by your
local, authorized Crusader Challenger Engines Certied
Dealer.