Crusader Challenger 6.0L Catanium CES User Manual

50
L510032-16
VISUAL INSPECTION
It is important for the owner/operator to visually inspect
the complete engine assembly at regular intervals. Most
often, costly repairs can be avoided if potential problems
are corrected before there is a failure.
Inspect the complete engine assembly for obvious fuel,
oil, water or exhaust leaks. Check for loose, damaged
or missing parts. Check all hose clamps for adequate
tightness. Check the electrical system for loose or dirty
connections or damaged wiring.
ENGINE MAINTENANCE - 11
Touch up scratches, nicks and corrosion damage to
the exterior nish of the engine. Spray paint may be
obtained from your local Crusader Challenger Engines
Certied Dealer.
Protect engine nish from corrosion by periodically
spraying the engine exterior nish with a rust
preventative oil (such as WD-40).
TRANSMISSION FLUID CAPACITIES
Model All Models Type
Challenger, 1:1 Ratio
1,2
2.0 Quarts (1.9 L) DEXRON III
Mobiltrans SHC 50
Challenger Power-Plus V-Drive, All Ratios
1,2
1.5 Quarts (1.42 L) synthetic - R190250
1 - Engine Fluid Capacities are dependent on installation angle. DO NOT overll the crankcase or
transmission. Remove excess uid above the “FULL” mark on the dipstick. Check oil with the boat at its
normal, level, at rest position on the water. Ensure that ballast systems (if equipped) and excess water in
the bilge have been purged. If the boat is on a trailer, the trailer must be level and adjusted to represent
the boat’s normal resting state on the water. Oil capacities are approximate, and may not include capacity
needed for transmission cooler and oil lines. Refer to the Checking Fluid Levels instructions page 29 and
Changing Oils instructions page 46, of this manual, for complete instructions, important notes and Cautions
for checking engine oil levels. Always use the dipstick to determine the exact quantity of oil required. Add
the correct amount of oil to ll to the “FULL” mark on the oil level dipstick.
2 - Refer to the Checking Fluid Levels instructions pages 30-31 of this manual for complete instructions for
checking transmission uid levels. IMPORTANT: 80 Series Challenger transmission uid levels are checked
at operating temperature and immediately after shutdown of the engine.
ENGINE FLUID CAPACITIES
Model ALL MODELS
Crankcase Oil Capacity
W / NEW FILTER Start with 4 Quarts (4.5 L)
1

Crusader Challenger 6.0L Catanium CES Specifications

General

Brand	Crusader
Model	Challenger 6.0L Catanium CES
Category	Engine
Language	English