Installing Equipment
A number of optional devices may be fitted for use with the Smoke Test. Please refer to the
operating instructions for details of usage.
DX260-1xx SMOKEHEAD (Cabled)
The DX260-1 Smokehead is plugged in to a connector positioned on its cradle base. The base
is then connected to the host equipment. The appropriate Sampling Pipe is then connected to
the Smokehead.
The Smokehead should be returned to base
when not being used.
DX260-1xxBT SMOKEHEAD (Wireless)
The DX260-1BT wireless Smokehead uses wireless technology to communicate directly with the
host computer. The Smokehead has rechargeable batteries built in to enable approximately 1.5
hours of continuous use between charges.
The Smokehead should be returned to its charger between tests to keep the batteries charged. The
Smokehead will go into hibernation mode if it is not being communicated to by the computer whilst it
is off the charger base for longer than approximately 6 minutes.
To Next Page
Loading...
