EasyManua.ls Logo

Crystal CRW 400 - User Manual

Crystal CRW 400
38 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
BULAŞIK YIKAMA MAKİNELERİ
MONTAJ ve KULLANIM KILAVUZU
CRW 400
CRW 500
CRW 1000

Table of Contents

Questions and Answers

  • M
    Marie JonesAug 11, 2025
    Why is the Crystal Dishwasher not cleaning dishes properly?
    • D
      dnelsonAug 11, 2025
      If your Crystal Dishwasher isn't cleaning dishes effectively, several factors could be at play. First, ensure you're using high-quality detergent and rinse aid, and verify their levels are adequate. Blocked dishwashing arms can also hinder performance, so clean them thoroughly. Additionally, make sure to clean all filters. Check the water pressure to ensure it's sufficient. Remove any coarse dirt from plates before loading them into the dishwasher. Marks on dishes may be due to lime, requiring the use of a softening agent. If you're using a softening agent, check the salt or chemical level.
  • J
    James SwansonAug 18, 2025
    What to do if Crystal CRW 400 Dishwasher takes too much water?
    • C
      Carlos BishopAug 18, 2025
      If your Crystal Dishwasher is taking in too much water, try the following steps. First, discharge all the water inside the device and fill it back again. Clean all filters to ensure they are not blocked. Make sure the plug or outlet is also not blocked. Clean the filter of the drainage pump. If, after all these steps, the device continues to take in water, disconnect the electric and water connections and call the service.
  • S
    sergio03Aug 25, 2025
    How to fix a Crystal Dishwasher that won't take water?
    • D
      David CopelandAug 25, 2025
      If your Crystal Dishwasher is not taking in water, start by checking if the water valve is open. Next, confirm that the water inlet hose is not blocked or bent. Also, verify that the power lamp illuminates. Finally, discharge all the water inside the device and fill it back.
  • V
    Valerie StephensAug 29, 2025
    Why is my Crystal CRW 400 Dishwasher taking water slowly?
    • C
      charlottecharlesAug 29, 2025
      If your Crystal Dishwasher is slow to fill with water, verify that the water inlet valve is fully open. Also, confirm that the water pressure is a minimum of 2 bars. Ensure that the rinsing arms are not blocked and check that the water inlet hose is not blocked or bent.
  • V
    Victoria PerrySep 4, 2025
    What to do if Crystal CRW 400 Dishwasher is not heating water?
    • A
      andrew30Sep 4, 2025
      If your Crystal Dishwasher isn't heating, first, discharge all the water inside the device and fill it back. Make sure the water inlet temperature is within the specified values. Check the water level in the tube. If the resistance has failed, call technical service.

Crystal CRW 400 Specifications

General IconGeneral
TypeFreestanding
Capacity12 place settings
Number of programs4
Energy RatingA
Delay StartYes
Dimensions (HxWxD)85 x 60 x 60 cm