Bulaşık Yıkama Makineleri - Professional Dishwashers
Montaj ve Kullanım Kılavuzu - Installation and User's Guide
24
affected. Water softening device must be used on the regions where lime
condition is unknown or lime water is present.
The clean water entering to device must have temperature of +4
o
C to
+55
o
C. Water having less or more temperatures might give damage to
your device, and also adversely affects dishwashing performance.
The pressure of device entering to the device can vary according to the
region at which device is used. Water pressure entering to the device
must be measured at the moment of installation. According to the
measured values, following procedures must be realized:
Water pump must be installed.
No need for an additional procedure.
Pressure reducing valve must be
used.
In case of failure to make applications mentioned above, dishwashing
performance must be adversely affected.
There must be water outlet at the area, groun or wall where device
operates. Because device has internal drainage pump, outlet is suitable
for use as long as it is not higher than 600 mm from floor. If you are using
a machine without drain pump, then the water outlet must be on ground
level.
Boiler of device must be adjusted to operate at 55
o
C and water tank at
85
o
C. These values must not be changed from thermostats in order to
avoid affecting dishwashing performance.
To Next Page
Loading...