Reset
If for some reason the XP2i needs to be reset, remove any battery for at least one minute, then reinstall the battery. If the reset is successful, the XP2i will
start operating without pressing the
(on/o) button. Reset will clear the zero, peak values will be reset to the current reading, and the XP2i will be set to the
default engineering units.
!
WARNING: Do not remove or change the batteries in hazardous locations.
Communications/Programming
The XP2i responds to a query-based command language which allows remote control of the gauge. Please refer to the XP2i Programming Instructions for
documentation of this feature.
To Next Page
Loading...