Crystal XP2i - Software, Parts & Accessories

Support  37
XP2i Operation Manual

SOFTWARE
LabVIEW™ Drivers and Programming Instructions
Control and communicate with XP2is using National Instrument’s LabVIEW, or our Programming Instructions. Integrate XP2is into your test environment!
CongXP Conguration Software
Use CongXP to disable unwanted pressure units, set default pressure units, change water density, adjust calibration, and more via the RS-232 interface.

REPLACEMENT PARTS
The only user-replaceable parts are the batteries and the included CPF adapter tting.

ACCESSORIES
P/N 2984 AC Adapter Kit
Permits operation of an XP2i from an AC supply of 90 - 264 VAC and 47 - 63 Hz. Includes interchangeable international plugs (for USA, Europe, U.K., and Australia).
Adapter will not charge batteries, but in the event of AC power loss, XP2is will automatically revert to battery operation.
!
WARNING: Do not use the AC Adapter Kit in hazardous locations.
P/N 3009 Plastic Carrying Case
35.6 cm (14”)L x 27.9 cm (11”)W x 8.3 cm (3¼”)H with egg-shell foam interior.
P/N 3696 Protective Boot
Skydrol™ resistant protective boot.
!
WARNING: Do not use the Plastic Carrying Case or Protective Boot in hazardous locations.
P/N 2955 6” Gauge Adapter Kit
Adapts the 4½” Panel Mount (F4 option) to t into a 6” gauge cutout.
P/N 2956 8½”Gauge Adapter Kit
Adapts the 4½” Panel Mount (F4 option) to t into an 8½” gauge cutout.
P/N 3313 USB-RS232 Adapter
USB B receptacle to RS232 DB9M.
!
WARNING: Do not use the USB-RS232 Adapter in hazardous locations.
P/N 2400 RS232 Cable
DB-9 male to DB-9 female straight pass-through cable.
!
WARNING: Do not use the RS232 Cable in hazardous locations.