Crystal XP2i - DataLoggerXP Terminology; Typical Usage

Data Logging with DataLoggerXP  11
XP2i Operation Manual
DataLoggerXP Terminology
Clear. . . . . . . . . . . . . . . . . . . . . Removes all stored data from the XP2i memory. Individual runs cannot be removed.
Download . . . . . . . . . . . . . . . The act of copying stored data from the XP2i to a computer using DataLoggerXP software.
Events . . . . . . . . . . . . . . . . . . . Non-data readings, optionally displayed as part of a run. These include tare values, low battery indications, or logging parameters.
Logging Interval . . . . . . . . . The time, in seconds, between each data point.
Logging Type . . . . . . . . . . . . The type of data stored for each reading.
Logging Parameters . . . . . The Logging Interval and Logging Type are referred to, in this document, as the Logging Parameters.
Run . . . . . . . . . . . . . . . . . . . . . . A set of one or more readings taken by the XP2i. The user can specify dierent logging parameters for each successive run.
Note: A maximum of 64 runs can be stored in memory.
Typical Usage
While there are a variety of ways in which the DataLoggerXP software and XP2i can be used, a typical way to use the DataloggerXP
might be like this:
1
Set the logging parameters
– either with DataLoggerXP software or directly from the keypad.
2 Enable data logging mode (the Record icon (
) will illuminate).
3 Take a recording.
4 Use DataloggerXP software to download your data into an Excel worksheet or a text le.