CSI CM32 - Softener Specifications

3
WARNING
Lubricants
Do NOT use Vaseline, oils, hydrocarbon lubricants or spray silicone anywhere! Petroleum base lubricants will cause
swelling of o-rings and seals. The use of other lubricants may attack plastic Noryl®. It is recommended that Dow
Corning® silicone grease be used as a lubricant for all control valves. Dow Corning® 7 Release Compound is used in
the manufacture of Chandler Systems control valves. (Part # LT-150)
Sealants
Pipe dope and liquid thread sealers may contain a carrier that attacks some plastic materials. It is recommended that
Teon® tape be used to seal plastic Noryl® threaded ttings.
Res-Up
The use of Res-Up or any other resin cleaners is prohibited. These cause deterioration of the control valve and
VOIDS warranty.
Softener Specications
General SpecicationsGeneral Specications CM24 CM32
Grains Capacity - Regeneration / Lbs Salt Used* 20,000 / 7.5 27,000 / 9
Maximum Raw Water Hardness (grains) 50 75
Maximum Clear Iron / Manganese 3 5
Exchange Resin (cu ft per tank) .75 1.0
Mineral Tank Size 9 x 35 9 x 35
Service Flow Rate** (gpm) 10.0 11.0
Backwash Flow Rate (gpm) 2.0 2.0
Gallons Used / Regeneration 86 88
Space Required (D x W x H) 23 x 14 x 45 23 x 14 x 45
Approximate Shipping Weight (lbs) 88 100