EasyManuals Logo

CSL DualCom GSM Mk1 User Manual

CSL DualCom GSM Mk1
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
15
Aux Output
The Aux relay contacts, C, NO and NC can be programmed to :
a) Change state if a tellback signal is generated by the alarm abort sequence
or is sent to the DualCom from a remote centre, OR...
b) Change state when the DualCom has successfully communicated with the
ARC, OR...
c) Change state when DualCom has been sent an SMS message from a
mobile phone. See page 29 for SMS Remote Control information.
Refer to the CS2054 Programmer Manual for full programming information.
Fig 7
tluaF etatsyaDnilenaP etatsteSnilenaP
ni+etatsteSnilenaP
mralA
tluafhtapNTSP
ylno
suounitnoC esluPdnoces2 noitcayalertluaFoN
tluafhtapoidaR
ylno
suounitnoC esluPdnoces2 noitcayalertluaFoN
dnaNTSPhtoB
tluafhtapoidaR
suounitnoC suounitnoC suounitnoC
lufsseccusnu3
NTSPnostpmetta
esluPdnoces2 esluPdnoces2 esluPdnoces2
lufsseccusnu01
NDVnostpmetta
esluPdnoces2 esluPdnoces2 esluPdnoces2
&NTSPliaflatoT
NDV
suounitnoC suounitnoC suounitnoC
Fault & Auxilliary Relay Outputs
The Fault and Aux relays operate when the DualCom has fault and other condi-
tions.
Where the installation is specified to the EN 50131 and PD6662 standards then
use of the DualCom GPRS is recommended.
For compatiability with older Control Panels, the ‘Normal’ mode of operation is
supplied. See Fig 7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CSL DualCom GSM Mk1 and is the answer not in the manual?

CSL DualCom GSM Mk1 Specifications

General IconGeneral
BrandCSL
ModelDualCom GSM Mk1
CategoryPDA
LanguageEnglish