33
SMS Remote Control
The AUX output relay and each of the 8 outputs on the CS1050 Expansion
Board (when fitted) can be controlled by sending the DualCom an SMS mes-
sage from a mobile phone. See pages 15 and 16.
These outputs can also be remotely controlled via the GSM radio path using
the CS0054 Programmer Software.
All SMS Text commands that can be sent to the DualCom begin with the 6 digit
security code with no spaces between digits. This is followed by the Com-
mand. The Command may be Text characters or Numeric, whichever you find
easier. Refer to the table below. You can put spaces between the 6 digit secu-
rity code and the Command if you find this easier. Where Text is sent it must
be upper-case.
Ensure that the 6 digit security code is programmed in the DualCom’s NVM.
Ensure also that SMS Reception is enabled in the NVM. Note: If these are
missing or disabled then SMS Remote Control will not operate.
noitcnuF edoCytiruceS
txeT
dnammoC
ciremuN
dnammoC
ylpeR setoN
sutatS
654321
,etatsMSG&NTSP
&htgnertS.giSoidaR
egatlovylppuS
noisreVerawtfoS
654321 REV
llaCtseTdneS
654321 TSET
teseR
654321 TESER
NOntuptuO
654321 NOnO 1n1
no8ot1tuptuO=n
draoBrednapxE
FFOntuptuO
654321 FFOnO 0n1
no8ot1tuptuO=n
draoBrednapxE
NO8-1stuptuO
654321 NO0O 101 ffOtuptuOhcaeswohS
nostuptuO8llA
draoBrednapxE
FFO8-1stuptuO
654321 FFO0O 001 ffOtuptuOhcaeswohS
nostuptuO8llA
draoBrednapxE
ETATS8-1stuptuO
654321 0O 01
tuptuOhcaeswohS
ffOronO
nostuptuO8llA
draoBrednapxE
NOtuptuOxuA
654321 NOAO 112
FFOtuptuOxuA
654321 FFOAO 012
ESLUPtuptuOxuA
654321 PAO 212
ETATStuptuOxuA
654321 AO 12
tuptuOxuAswohS
ffOronO
dnammoCdilavnI
654321
tongnihtynA
evobadetsil
tongnihtynA
evobadetsil
dnammoCdilavnI
edoCytiruceSdilavnI