Emizon TCD
Step 5 - Commissioning With ARC
• Call the ARC with the TCD serial number. The ARC will then ‘associate’ or link the
TCD to the customer details on their system and ‘activate’ the TCD.
• Press the ‘Set’ (R H) button for 5 seconds.
• The display will then alternate between t L 0 1 and then display CA (Completely
Activated) indicating a successful activation.
• The IP LED 2 0 1 and GPRS LED 2 0 2 will change to solid green to indicate that
both paths are communicating with the Emizon Service Platform.
• For added security there is a time out period, usually 20mins, to press the set
button following ARC • activation.
• The following codes are shown on the display:
t L 0 1 (TCD initial State) ⇒ C A (Completely Activated)
If the TCD is re-powered at any time you will need to repeat the ARC commission
process
To Next Page