[#XXXXXX|Nti00:00:00/YW831|ATCD RESTARTED]
Previous Alarm discarded
[#XXXXXX|Nti00:00:00/YS832|ATCD EVENT DELIVERY FAIL]
[#XXXXXX|Nti00:00:00/YK832|ATCD EVENT DELIVERY RESTORED]
Low Battery fault
[#XXXXXX|Nti00:00:00/YT833|ATCD PSU VOLTAGE LOW]
[#XXXXXX|Nti00:00:00/YR833|ATCD VOLTAGE RESTORED]
Self Test Fail (flash CRC fail)
[#XXXXXX|Nti00:00:00/YF834|ATCD SELF TEST FAIL]
Primary Path Local Fault
[#XXXXXX|Nti00:00:00/NT840|ATCD PRI IFACE FAIL]
[#XXXXXX|Nti00:00:00/NR840|ATCD PRI IFACE RESTORE]
Secondary Path Local Fault
[#XXXXXX|Nti00:00:00/NT841|ATCD SEC IFACE FAIL]
[#XXXXXX|Nti00:00:00/NR841|ATCD SEC IFACE RESTORE]
Upload / download session
[#XXXXXX|Nti00:00:00/RB835|ATCD UDL START]
[#XXXXXX|Nti00:00:00/RS835|ATCD UDL END]
Firmware Updated (whilst activated)
[#XXXXXX|Nti00:00:00/YG836|ATCD FIRMWARE UPDATED]
Periodic Test Alarm
[#XXXXXX|Nti00:00:00/RP837|ATCD PERIODIC TEST]
ACK bad panel data to prevent panel getting stuck in a loop
[#XXXXXX|Nti00:00:00/YS838|ATCD BAD PANEL DATA ACKED]
Alarm data was lost e.g. no zero block at end of SIA events
[#XXXXXX|Nti00:00:00/RT839|ATCD DATA LOST]
PATH TESTS CONTACT ID
E601 01 801 - Ethernet Primary
E601 02 801 - Ethernet Secondary
E601 01 802 - GSM Primary
E601 02 802 - GSM Secondary
E601 01 803 - PSTN Primary
E601 02 803 - PSTN Secondary
SIA
[#XXXXXX|Nti00:00:00/pi001/TX801|ATCD IP PRI TEST] - Ethernet Primary
[#XXXXXX|Nti00:00:00/pi002/TX801|ATCD IP SEC TEST]- Ethernet Secondary
[#XXXXXX|Nti00:00:00/pi001/TX802|ATCD GPRS PRI TEST]- GSM Primary
[#XXXXXX|Nti00:00:00/pi002/TX802|ATCD GPRS SEC TEST]- GSM Secondary
[#XXXXXX|Nti00:00:00/pi001/TX803|ATCD PSTN PRI TEST]- PSTN Primary
[#XXXXXX|Nti00:00:00/pi002/TX803|ATCD PSTN SEC TEST - PSTN Secondary
EN-COMPLIANT INSTALLATIONS
To achieve EN-Compliant installation, additional and/or specific requirements may be
To Next Page