Not being able to connect is usually caused by not having the correct WiFi password. Check the 2.4G
password in your router settings, sometimes it is not the same as the 5G one.
We found that there is a setting in xFinity access points that can prevent it from connecting. Find and
uncheck the 'Prefer private Connections' setting in your routers configuration.
Also make sure that your access point if not filtering by MAC address for new connections.
Ubiquity networks - If you have slow performance or difficuly connecting you may need to enable
Legacy Wireless Mode. Please consult your devices documentation for more information.
Starlink Wifi - Try seperating the 5G and 2.4G networks in you Starlink settings.
what are the recommended settings for the Icom 910/970?
Our users have found that 19200 baud, "Main Up/Sub Down" and an update interval of 200ms work
well. Like other radios, it should not be in Sat mode. You cannot use the RIT on these radios since it
only controls the top VFO which is the uplink. Instead, when tracking a linear satellite, you can Unlock
the VFOs on the SAT and find yourself using the radio's VFO knob. Once you hear yourself clearly, you
can re-lock the VFO's and move up and down the band with the VFO knob and the SAT will keep
everything in sync and adjusted for doppler.
Copyright © CSN Technologies Inc. 2022
APRS is a registered trademark Bob Bruninga, WB4APR
To Previous Page
Loading...
Need help?
General