CTEK 1055 User Manual (English)

To Next Page

EN • 3

SAFETY

• The charger is designed for charging only

batteries according to the technical speciﬁca-

tion. Do not use the charger for any other

purpose. Always follow battery manufacturers

recommendations.

• Never try to charge non rechargeable batteries.

• Check the cables prior to use. Ensure that no

cracks have occurred in the cables or bend pro-

tection. A charger with damaged cables must

not be used. A damage cable must be replaced

by a CTEK representative.

• Never charge a damaged battery.

• Never charge a frozen battery.

• Never place the charger on top of the battery

when charging.

• Always provide for proper ventilation during

charging.

• Avoid covering the charger.

• A battery being charged could emit explosive

gases. Prevent sparks close to the battery.

• All batteries fail sooner or later. A battery that

fails during charging is normally taken care of

by the chargers advanced control, but some

rare errors in the battery could still exist. Don’t

leave any battery during charging unattended

for a longer period of time.

• Ensure that the cabling does not jam or comes

into contact with hot surfaces or sharp edges.

• Battery acid is corrosive. Rinse immediately with

water if acid comes into contact with skin or

eyes, seek immediate medical advice.

MANUAL

CONGRATULATIONS

to the purchase of your new professional switch mode battery charger. This charger is

included in a series of professional chargers from CTEK SWEDEN AB and represents the

latest technology in battery charging.

Need help?

Do you have a question about the CTEK 1055 and is the answer not in the manual?

CTEK 1055 Specifications

General

Model	CTEK 1055
Type	Battery Charger
Output Voltage	12V
Ripple	<4%
Ambient Temperature	-20°C to +50°C
Insulation Class	IP65
Weight	0.6 kg
Input Voltage	220-240V
Battery Types	Wet, MF, AGM, GEL
Protection	Short circuit
Charging Modes	8 step fully automatic charging cycle