CTEK MXS 5.0 User Manual

EN • 3
EN
MANUAL
INTRODUCTION
MXS 5.0 (1090) is a switch mode charger with both float
and pulse maintenance and is a part of a series of battery
chargers from CTEKSwedenAB. These chargers represent the
latest technology within battery charging. A MXS 5.0 (1090)
gives the battery maximum life.
IMPORTANT SAFETY
INSTRUCTIONS
CALIFORNIA PROPOSITION 65
WARNING: This product contains chemical known to the state
of California to cause cancer or reproductive toxicity.
1.
SAVE THESE INSTRUCTIONS
– This manual contains important safety and operating
instructions for battery charger model MXS 5.0 (1090).
2. Do not expose charger to rain or snow.
3. Use of an attachment not recommended or sold by CTEK
may result in a risk of fire, electric shock or injury to
persons.
4. To reduce risk of damage to electric plug and cord, pull
by the plug rather than cord when disconnecting charger.
5. An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire and electric shock. If an extension cord
must be used, make sure that: a) Pins on plug of exten-
sion cord are the same number, size and shape as those
of plug on charger; b) Extension cord is properly wired
and in good electrical condition; and c) Wire size is large
CTEK COMFORT CONNECT – eyelet ¼” (M6)
CTEK COMFORT CONNECT
MAINS CABLE
CTEK COMFORT CONNECT – clamp
CHARGE CABLE
SUPPLY PLUG*
*Supply plugs may differ to suit your wall socket.
50013552C MXS 5.0 NA, Manual, Print file 002.indd 1 2016-11-21 15:01:25

CTEK MXS 5.0 Specifications

General

Input voltage	220-240 V
Input frequency	50/60 Hz
Battery voltage	2 V
Cable color	Black
Operating temperature (T-T)	-20 - 50 °C
Number of batteries supported	-
Product color	Black, Silver

Weight and Dimensions

Depth	168 mm
Width	65 mm
Height	38 mm
Weight	600 g

Summary

Important Safety Instructions

General Safety Guidelines

Save instructions, avoid rain/snow, use recommended attachments, pull by plug, use proper extension cords.

Important Safety Instructions (continued)

Charger Condition and Maintenance Safety

Explosive Gases Warning

Lead-Acid Battery Hazards and Precautions

Personal Precautions

Safety Measures During Battery Operation

Preparing to Charge

DC Connection Precautions

Connecting Battery in Vehicle

In-Vehicle Connection Safety and Steps

Position cords, avoid hazards, check polarity, determine ground, connect clips correctly, then disconnect.

Connecting Battery Outside Vehicle

Out-of-Vehicle Connection Safety and Steps

Check polarity, connect RED to POSITIVE, BLACK to NEGATIVE away from battery, avoid facing during connection.

Important Safety Information

Charger Usage Guidelines

Charge specified batteries only, check cables, avoid jamming, never charge damaged/frozen batteries, avoid covering.

Unattended Charging and Battery Monitoring

Do not leave battery unattended; monitor charging; check Step 7 within 50 hours or disconnect.

Battery Maintenance and Child Safety

Connecting and Disconnecting Charger

Operating Instructions

Connecting Charger and Battery

Selecting Charging Program and Options

Following the 8-Step Charging Process

Stopping the Charging Process

Charging Programs and Options

Charging Program Combinations

Charging Process Steps Explained

Ready to Use Time Estimates

Error Lamp Troubleshooting

Checking Error Lamp Indicators

Power Lamp Indicators

Interpreting Power Lamp States

Technical Specifications