BULK CHARGING TIME
TEMPERATURE PROTECTION
The charger is internally protected from becoming overheated. The
power reduces when the ambient temperature increases.
MAINTENANCE
The MULTI XS 3600 does not need any specic maintenance.
Please note that dismantling the charger will cancel the warranty.
A defective power cord has to be replaced. Keep your charger
clean. Wipe it with a soft tissue and mild cleaning liquid. The
charger must be disconnected for cleaning.
EQUIPMENT
The MULTI XS 3600 is delivered with a set of battery leads with
battery pole clamps. Leads with eyelet terminals are available as
accessory.
SPECIFICATION
Voltage AC 220-240 VAC, 50-60 Hz. Output power is
reduced at lower input voltage. A perfect
charge will still be achieved.
Current 0.6 A rms
Starting Current < 25 A
Back Current Drain* 1.3 mA
Charging Voltage Nominal: 12 V 14.4 V or 14.7 V.
Ripple** Max 50 mV rms, max 0.13 A.
Charging Current 3.6 A max
Ambient Temperature - 20°C till + 50°C. Automatic reduction of
power at increased ambient temperature.
Cooling Natural convection.
Charger type Three step fully automatic IU
o
U
p
, with
pulse maintenance mode.
Type of batteries All types of lead-acid batteries
(Wet, MF, VRLA, AGM and GEL.).
Battery Capacity 1.2 till 120 Ah
Dimensions 165 x 61 x 38 mm (L x W x H)
Insulation IP 65
Weight 0.5 kg
*) Back Current Drain is what drains the battery if the charger
is connected without the power cord connected. Multi XS 3600
extremely low Back Current Drain is equal to 1 Ah/month. A normal
gure for other charger is 1 Ah/day, which could ruin your battery
**) Quality of the current and voltage is very important. A linear
charger produces a current with a high ripple. High current ripple
heats up the battery and makes the positive electrode age prema-
turely. High voltage ripple could harm other equipment connected
to the battery. Multi XS 3600 produces a high quality current with
very low ripple. There is no need to disconnect the battery from
the vehicle.
Battery size
Time
Mode
LIMITED WARRANTY
CTEK SWEDEN AB, Rostugnsv. 3, SE-776 70 VIKMANSHYTTAN,
SWEDEN issues this limited warranty to the original purchaser
of this product. This limited warranty is not transferable. CTEK
SWEDEN AB guarantees this unit for two years from the date of
purchase against defect workmanship or material. It is the obliga-
tion of the purchaser to forward the unit together with proof of pur-
chase to the manufacturer or its representative with transportation
cost prepaid. This warranty is void if the unit is abused, handled
carelessly or repaired by anyone other than CTEK SWEDEN AB
or its authorized representative. CTEK SWEDEN AB makes no
warranty other than this limited warranty and expressly excludes
any implied warranty including any warranty for consequential
damages. This is the only expressed limited warranty and CTEK
SWEDEN AB neither assumes nor authorizes anyone to assume
or make any other obligation towards the product other than this
limited warranty.
DECLARATION OF COMPLIANCE
Manufacturer: CTEK SWEDEN AB, Rostugnsvägen 3, SE-776 70
VIKMANSHYTTAN, SWEDEN, Tel: + 46 225 351 80
Declares under sole responsibility that the battery charger MULTI
XS 3600, to which this declaration relates complies with the follow-
ing standards: EN60335-1, EN 60335-2-29 following the provisions
of directive 73/23/EEC amended by 93/68/EEC and EN 55014-1,
EN 61000-3-3, EN 61000-3-2, EN 55014-2 following the provisions
of directive 89/336/EEC amended by 92/31/EEC and 93/68/EEC.
Vikmanshyttan Sweden, 2002-03-12
Börje Maleus, Managing Director, CTEK SWEDEN AB
CTEK SWEDEN AB
Rostugnsvägen 3
SE-776 70 VIKMANSHYTTAN
SWEDEN
Fax: + 46 225 307 93
www.ctek.se
13840162_UK