CTM 360 Series User Manual

1318 QUAKER CIRCLE PO BOX 589 SALEM, OHIO 44460
PHONE: 330-332-1800
FAX: 330-332-2144
DESIGNERS AND MANUFACTURERS OF PRESSURE
SENSITIVE LABELING EQUIPMENT AND CUSTOM
PRODUCT HANDLING
360 SERIES LABEL
APPLICATOR
MAINTENANCE
&
SERVICE
MANUAL
REVISION 360-2c.10.1
050103

CTM 360 Series Specifications

General

Brand	CTM
Model	360 Series
Category	Label Maker
Language	English

Summary

Introduction to the 360 Series Label Applicator

Electrical Supply Requirements

Specifies voltage, amperage, and frequency requirements for the applicator.

Environmental Operating Conditions

Details operating temperature and humidity ranges for safe use.

Machine Terms and Components

Applicator Nose Types

Defines Blow Box, Merge, and Tamp applicator nose assemblies.

Web Handling Components

Components like unwind, rewind, and dancer arm for web management.

Display Panel Operation and Setup

Interface Navigation Basics

Covers main menu, online status, and applicator type selection.

Label Setup Parameters

Details label length, stop, auto/manual setup, and air blast settings.

Advanced Options and Features

Explains applicator options, label formats, and placement.

Product and Encoder Configuration

Setup for product detection, detector lockout, and encoder.

Rear Panel Connectors

Interface Connection Ports

Describes the function of each connector on the rear panel.

General Setup Procedures

Job Setup and Label Threading

Initial steps for setting up the applicator and threading labels.

Label Sensor Setup

Details on installing and aligning the label sensor for optimal performance.

Label Length and Stop Setup

Procedures for accurately measuring and setting label length and stop.

Web Speed and Slew Speed Settings

Setting applicator speed parameters for optimal performance.

Labeler Type Specific Setup

Merge Applicator Setup

Specific setup for merge type, including label profiling.

Air Blow Applicator Setup

Specific setup for air blow type, including alignment and air settings.

Tamp Applicator Setup

Specific setup for tamp type, including alignment and vacuum settings.

Product and Encoder Configuration

Product Sensor Setup

Details on setting up the reflective product sensor.

Encoder Option and Setup

Configuration and setup for the encoder option.

Crossover and Printer Options

Crossover Option for Zero Downtime

Enables 'zero downtime' operation by linking two applicators.

Printer Integration Setup

Covers Loose Loop and Imprinter accessory setup.

Label Options and Configuration Menu

Label Dispensing Control Options

Controls multiple labels, missing labels, and skip counting.

Configuration Menu Access

Accesses factory settings and special options.

Maintenance and Troubleshooting

General Maintenance Procedures

Routine maintenance tasks for daily, weekly, and monthly upkeep.

Troubleshooting Common Issues

Guides users through diagnosing and resolving common problems.

Fault Code Register

Lists fault codes, types, and their meanings for diagnostics.

Operational Aids and Accessories

Operational Flowcharts

Visual operational sequences for different applicator types.

Available Accessories

Details optional accessories like crossover, imprinter, and sensors.

Spare Parts and Drawings

Recommended Spare Parts List

Lists recommended spare parts for the 360 series applicator.

Technical Drawings

Electrical and mechanical diagrams of the applicator and components.

Changeover Instructions

Applicator Hand Changeover

Procedures for changing applicator configuration to opposite hand.

Nose Assembly Changeover

Steps to transfer and rotate nose assemblies for opposite hand dispense.

Rewind and Wiring Changeover

Procedures for changing rewind and wiring for opposite hand dispense.