Instruction BookletHS-925
1
2
5
3
4
20
User should inspect the tires frequently for damage, the presence of foreign bodies, unusual
wear and sufficient tread depth. If replacement tires are needed, please contact the nearest
dealer.
Front and rear wheel : Ø 370 x 90 mm (15”) air tire.
The following areas require periodic inspection :
•Tire pressure between 30-35 psi
•Tread depth drops below 0.5 mm
Recommended range of storage,
Temperature : -30°c ~ +50°c, Humidity : 25% ~ 85%
Follow these easy steps to replace the tire :
1.Turn off the scooter and remove the key. Make sure
the lever is in D position before you lift the scooter.
2.Use an ratchet and socket to remove the drive
wheel screw from the centre hub of the wheel. Pull the wheel off of the axle.
3.Separate the tire from the rim.
4.Remove the old tire and replace it with a new tire.
5.Slide the wheel back onto the shaft.
6.Install the drive wheel nut into the centre hub and verify the key is lined up with axle
and wheel,then tighten to secure it in place. (Torque 300 ± 30kgf - cm)
All maintenance and repair of scooter should be done by an authorized dealer.
Tire :
Component 5 is for rear wheel only
•Do not use any abrasive or scouring liquids for cleaning. Only use a damp cloth and
gentle detergent.
•Do not use hose pipe or splash water directly onto the scooter as this may cause damage
to electronics.
7-4 CLEANING YOUR SCOOTER
•User should inspect the scooter regularly to keep scooter in good running order.
•Check if the electrical cable connectors are fully connected.
•All maintenance and repair of scooter should be done by an authorized dealer.
7-5 MAINTENANCE
Only use damp cloth and a little soap to wipe the seat. Do not use abrasive cleaners as
this will damage the seat.
Seat Upholstery :
•
The frame and shroud of the scooter can be wiped with lightly damp cloth. Do not use
abrasive cleaners as this will damage the coating.
•
Car polish can be used to keep the paint and frame in pristine condition.
Frame / Shroud :
•Please store the scooter in a dry location. If store the scooter in long time, please
disconnect the battery terminals.
•Do not store your scooter where it will be exposed to source of direct heat, damp, oil,
acid, alkaline, or where Ozone could be possibly generated. All of the above will minimize
scooter / tire cycle and shorten its lifetime.
Storage :
To Next Page
Loading...
