Instruction BookletHS-925
12
•Open the seat storage box and remove the storage box. (see section 5-1 General
operation - seat storage box) Be careful of the seat falling down. (Figure 12)
•Connect the wire and put the storage box back. Fasten the 3 screws to assemble (see
section 5-5 Disassembling your scooter-disassembling seat storage box) (Figure 13)
5-1 GERNERAL OPERATION
5.OPERATION OF SCOOTER
Battery connecting wire must be connected before using the scooter for the first
time.
•Scooter will go into Sleep Mode with one long beep warning sound if no throttle activity
is detected for programmable time period. (Default programmable time is 10 mins.)
•When scooter is in Sleep Mode, the LCD display will be off automatically and the scooter
will not respond to commands.
•To wake up the scooter, turn the power (key) off and then on again.
Sleep Mode :
•Always ensure that the scooter is switched
off before getting on or off the scooter and
before removing any items of the scooter.
•Turning the scooter OFF whilst driving will bring
the scooter to an abrupt stop and danger.
•Turn the key to the right - Turn scooter on.
•Turn the key to the left - Turn scooter off.
•Turn on the scooter, control panel will be in standby
mode. (C)
Main Key Switch :
Figure 14
Figure 13Figure 12
•Pull the right throttle (A) to move scooter forward. Pull the left throttle (B) to move
scooter backward. This can be reversed by local dealer if required. (Figure 15)
•These are also your accelerator. The further you depress them, the faster you go.
(Subject to the position of speed control)
•Releasing both left/right throttles automatically operates the brakes to slow down and
stop. Brake light will be activated and have solid red light on for 5 seconds. (see section
3 Identification of parts)
Throttle :
To Next Page
Loading...
