Be certain that all lubrication fittings are assem-
bled in place, using the lubrication illustrations asa
guide.
Always
lubricate the tractor thoroughly before tak-
ing it to the field. Use a pressure lubricating gun.
Be sure all fittings are free from dirt and paint so
the lubricant is certain to enter the bearing.
Always force the lubricant through the full length
of each bearing until it emerges at the end, carry-
ing with it the worn lubricant and any dirt that may
have entered the bearing.
Miscellaneous working parts not provided with
lubrication fittings should be oiled daily with a
good grade of lubricating oil.
Lubricant is cheap. Use plenty of it. Worn parts
can be expensive to replace.
Keep your supply of lubricating oil and grease stored in clean containers,
and covered to protect from dust and dirt.
Keep the lubricating gun nozzle clean and wipe dirt from grease fittings
before lubricating.
The
symbols in the illustration indicate the
method of application and the hourly intervals to
apply the lubricant.
_.r:-~ Use a pressure lubricating gun and ap-
\ j ply IH 251 H EP grease (or equivalent No.
-2 multi-purpose lithium grease) suffi-
cient to flush out the old grease and dirt.
Lubricate at hourly intervals indicated on sym-
bols.
Dipstick,
use to check engine oil before
each use.
24
To Next Page
Loading...
Need help?
General
