Cub Cadet 1282 User Manual

Engine filler cap
and dipstick.
1.
LUBRICATION GUIDE
-Before Each Use
Check the oil (with the engine stopped) and add sufficient
new oil to bring it to the "FULL" mark on the dipstick. Do
not overfill. Do not operate the engine if the oil level is
below the "LOW" mark on the dipstick.
-After Every 10 Hours of Operation
Use IH 251 H EP grease or equivalent No.2 multi-purpose
lithium grease and apply sufficient grease to flush out old
grease and dirt.
2-
Steering knuckles (2).
(Both sides)
NOTE: After the first 10 hours only, remove the oil filterand
replace with a new filter. Refer to "MAINTENANCE."Change
the oil filter after 50 hours and every 100 hours of
operation thereafter.
3-
Transmission oil filter.
Use IH 251 H EP grease or equivalent No.2 multi-purpose
lithium grease and apply sufficient grease to flush out old
grease and dirt. NOTE: It may be necessary to rotate the
front axle to reach the grease fitting.
After Every 25 Hours of Operation
4.
Front Axle pivot bolt.
(Right side)
While the oil is warm, remove the drain plug (5) and drain
all of the oil from the crankcase. Replace the drain plug.
Refill the crankcase with new oil up to the "FULL" mark
on the dipstick. Refer to the "LUBRICATION TABLE" for
the proper quantity and viscosity to use.
5-
Engine
oil drain plug.
6-
Transmission
oil leveland
fill tube.
Check the oil with the engine stopped. Keep the lubricant
up to "FULL" mark on dipstick (6).
-After Every 50 Hours of Operation
7.Transmission
oil filter.
8-
Transmission oil filter.
NOTE: After the first 50 hours only, remove the oil filter
and replace with a new filter. Refer to "MAINTENANCE."
Change the oil filter every 100 hours of operation
thereafter.
Every 100 Hours of Operation
Change the oil filter and replace with a new filter. Refer to
"MAINTENANCE."
9-Steering gear housing.
(Center bottom)
Once a year, apply two strokes of the lubricator, using IH
251 H EP grease or equivalent No.2 multi-purpose lithium
grease.
NOTE: To locate the lubrication fitting, turn the front
wheels to the maximum right turn position. Then reach up
under the right side of the tractor frame to locate the fit-ting.
Once a year, apply a small amount of IH 251H EP grease
or equivalent No.2 multi-purpose lithium grease in theslots.
Speed Control Linkage
10-Cam plates.
Miscellaneous
Brake pedal shaft
Lubricate the brake pedal shaft and linkage with eight or
ten drops of engine oil.
26

Cub Cadet 1282 Specifications

General

Brand	Cub Cadet
Model	1282
Category	Lawn Mower
Language	English