14 Section 4— controlS and FeatureS
How To Apply Chemicals/Cleaning Solvents
Applying chemicals or cleaning solvents is a low pressure
operation.
NOTE: Use only soaps and chemicals designed for pressure
washer use. Do not use bleach.
To Apply Chemicals:
1. Ensure detergent siphon hose is attached to barbed fitting
location near high pressure hose connection of pump as
shown.
Figure 4-5
2. Place other end of detergent siphon hose with filter on it
into container holding chemical/cleaning solution.
NOTE: For every 7 gallons of water pumped 1 gallon of
chemical/cleaning solution will be used.
3. CC3224 – Install low pressure (black) nozzle into quick
connect fitting of spray wand, see “How To Use Spray
Wand” paragraph in this section.
CC3425, CC4033 – Install the black low pressure nozzle
into the quick connect fitting of the spray wand and rotate
the Dial-N-Wash to the MAX pressure setting as shown. See
"How To Use Spray Wand" paragraph in this section.
NOTE: To apply chemicals the black low pressure nozzle
must be installed and the Dial-N-Wash must be in the
MAX pressure setting as shown.
4. After use of chemicals, place detergent siphon hose into
container of clean water and draw clean water through
chemical injection system to rinse system thoroughly.
If chemicals remain in the pump, it could be damaged.
Pumps damaged due to chemical residue will not be
covered under warranty.
NOTE: Chemicals and soaps will not siphon if the black soap
nozzle is not installed on the spray wand.
To Next Page
Loading...
Need help?
General
