Belt Replacement
Reverse Drive Belt
Your tiller has been engineered with a belt made of special
material (Kevlar Tensile) for longer life and better performance. It
through you authorized service dealer.
Disconnect and ground the spark plug wire against the
engine.
Remove the belt cover from the left side of the tiller by 2.
removing the two self-tapping screws and hex stop nut
Remove belt from transmission pulley and then from
To reassemble the new belt, follow the instructions in 4.
reverse order. Be sure to place the wider side of the belt
against transmission and idler pulley while slimmer side
NOTE: Upon reassembly, make certain the belt is routed
over the idler pulley and inside of belt keepers by engine
Service
7
17
To Next Page
Loading...
