Attach the hose coupler to the water port on your decks
surface. See Fig. 6-2.
Turn the water on.4.
5.
the engine and place the throttle lever in the FAST (rabbit)
position.
6.
7.
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8.
position.
9.
Turn the water off and detach the hose coupler from the
deck running for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly dry.
Lubrication
WARNING! Before lubricating, repairing, or
brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel axles and rims is equipped with a
grease applied with a grease gun after every 25 hours of tractor
operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Deck Wheels
a grease fitting. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor
operation
Figure 6-2
Figure 6-3
21se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s
To Next Page
Loading...
Need help?
General
