EasyManuals Logo

Cub Cadet LTX1042 User Manual

Cub Cadet LTX1042
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Problem Cause Remedy
Engine fails to start 
2.

Throttle/Choke control lever not in correct 4.
starting position.
Fuel tank empty, or stale fuel. 5.
6.
Faulty spark plug. 7.
Engine flooded. 8.

Engage parking brake. 2.
Connect wire to spark plug. 
 4.
5.
old) gas.
Clean fuel line and replace fuel filter. 6.
Clean, adjust gap or replace plug. 7.
8.
Engine runs erratic Tractor running with Choke activated. 
2.
 
Vent in gas cap plugged. 4.
Water or dirt in fuel system. 5.
Dirty air cleaner. 6.
Move the Throttle/Choke control lever out of 
the choke position.
Connect and tighten spark plug wires. 2.
Clean fuel line; fill tank with clean, fresh 
gasoline and replace fuel filter.
Clear vent or replace cap if damaged. 4.
Drain fuel tank. Refill with clean, fresh 5.
gasoline.
Replace air cleaner paper element or clean 6.
foam precleaner.
Engine overheats Engine oil level low. 
Air flow restricted. 2.
Fill crankcase with proper amount and 
weight of oil.
Clean grass clippings and debris from around 2.

Engine hesitates at high

 Remove spark plug and reset the gap. 
Engine Idles rough 
Dirty air cleaner. 2.

Replace air cleaner element and/or clean 2.
pre-cleaner.
Excessive vibration Cutting blade loose or unbalanced. 
Damaged or bent cutting blade. 2.
Tighten blade and spindle. 
Replace blade. 2.
Mower will not mulch grass Engine speed too low. 
Wet grass. 2.
Excessively high grass. 
Dull blade. 4.

position.
Do not mulch when grass is wet. 2.
Mow once at a high cutting height, then 
mow again at desired height or make a
narrower cutting swath.
4.
Uneven cut Deck not leveled properly. 
Dull blade. 2.
Uneven tire pressure. 

2.
Check tire pressure in all four tires. 
Troubleshooting
8
29

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet LTX1042 and is the answer not in the manual?

Cub Cadet LTX1042 Specifications

General IconGeneral
Engine BrandKohler
Engine ModelCourage
Cylinders1
Cutting Width42 inches
Cutting Height1.5 - 4 inches
Transmission TypeHydrostatic
Blades2
Deck MaterialSteel
Turning Radius18 inches
Front Tires15 x 6 in
Rear Tires20 x 8 in
Warranty3-year limited

Related product manuals