Battery
CALIFORNIA PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
The battery is sealed and is maintenance-free. Acid levels cannot
be checked and fluid can not be added.
Always keep the battery cables and terminals clean and
free of corrosive build-up.
After cleaning the battery and terminals, apply a light coat
of petroleum jelly or grease to both terminals.
CAUTION: If removing the battery for cleaning,
When re-installing the battery, always connect the
the NEGATIVE (Black) wire. Be certain that the wires
are connected to the correct terminals; reversing
them could result in serious damage to your
Cleaning the Tractor
Any fuel or oil spilled on the machine should be wiped off
part of the machine, especially the belts and pulleys.
Smart Jet
part of its deck wash system.
underside and prevent the buildup of corrosive chemicals.
Drive the tractor to a level, clear spot on your lawn, near
enough for your garden hose to reach.
CAUTION:
chute is directed AWAY from your house, garage,
parked cars, etc.
2.
and stop the engine.
4. Attach the hose coupler to the water port on your decks
surface. See .
5. Turn the water on.
6.
the engine and place the throttle lever in the FAST (rabbit)
position.
7.
8.
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
Figure 6-3
9.
position.
Turn the water off and detach the hose coupler from the
cutting deck.
running for a minimum of two minutes, allowing the underside
of the cutting deck to thoroughly dry.
21Section 6 — Maintenance & adjuStMentS
To Next Page
Loading...
Need help?
General
