Cub Cadet RZT-S - Adjusting the Seat; Lower Deck Discharge Chute Deflector

11Section 3 — ASSembly & Set-Up
 Install the discharge chute deflector using the carriage
bolts, push nuts and flange lock nuts as shown in Figure

Discharge
Chute
Deflector
50” Deck
Shown
Flange Lock Nuts
Push Nuts
Carriage Bolts
Figure 3-8
Adjusting the Seat
To adjust the position of the seat, lift the seat adjustment lever
up. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked into

Figure 3-6
Lower Deck Discharge Chute Deflector
WARNING! Never operate the mower deck
without the chute deflector installed and in the
down position.
The discharge chute deflector must be installed before operating
the mower.
 Remove the keys that are attached with a zip tie to the
chute bracket.
2. Remove the flange lock nuts from the deck. Do not remove
the push nuts or carriage bolts, leaving them in place will

50” Deck
Shown
Flange Lock Nuts
Push Nuts
Carriage Bolts
Figure 3-7