Cub Cadet RZT-S User Manual

Section 6— Maintenance & adjuStMentS
22
 Turn the water off and detach the hose coupler from the

 

cutting deck running for a minimum of two minutes, allowing
the underside of the cutting deck to thoroughly dry.
Lubrication
WARNING! 

brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel spindles and rims is equipped with a grease

applied with a grease gun after every 25 hours of tractor operation.
Grease
Fittings
Figure 6-3
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Tires
WARNING! Never exceed the maximum inflation
pressure shown on the sidewall of the tire.

recommended or maximum psi. Do not overinflate. Uneven tire
pressure could cause the cutting deck to mow unevenly.
Cleaning the Tractor
Any fuel or oil spilled on the machine should be wiped off


part of the machine, especially the belts and pulleys.
Smart Jet™

part of its deck wash system.

underside and prevent the buildup of corrosive chemicals.

 Drive the tractor to a level, clear spot on your lawn, near
enough for your garden hose to reach.
CAUTION: 
chute is directed AWAY from your house, garage,
parked cars, etc.
 
and stop the engine.
2. 

 Attach the hose coupler to the water port on the left of
your deck surface. See Figure 6-2.
Nozzle Adapter
Adapter Lock Collar
Deck Wash Nozzle
Figure 6-2
4. Turn the water on.
5. 
the engine and place the throttle lever in the FAST
position.
6. 
7. 
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8. 
  position to turn the


Cub Cadet RZT-S Specifications

General

Turning Radius	Zero-Turn
Deck Material	Steel
Engine	Kohler
Horsepower	22 HP
Cutting Width	50 in
Transmission	Hydrostatic
Fuel Capacity	3.5 gal
Speed	7 mph
Weight	600 lbs