Cub Cadet Tank S S7232D User Manual

29se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s
Turn the radiator cap counterclockwise to the first stop to 
release any pressure.
2.
until the cap stops then lift cap off.

reaches the bottom of the filler neck overflow flange.
Wait a few minutes to allow as much air as possible to 4.
escape through the filler neck, then reinstall the radiator
cap.
Fill the overflow reservoir to the “FULL” mark.5.
6.
the engine.
Recheck the coolant level in the overflow reservoir and 7.
refill as needed. Reinstall the reservoir cap.
If engine over-temp light comes on or stays on after filling 8.
radiator and reservoir, see your Cub Cadet service dealer to
bleed air from system.
Changing the Engine Coolant
The engine coolant should be drained and replaced with new

service dealer to have the engine coolant changed.
Adding Hydraulic Oil (use SAE15W40)

brake.
2.
switch.
Raise the seat forward to expose the hydraulic oil fill point.
4.

5.

fill neck.
6. ⁄ ” below the oil tank

Hydraulic Oil Tank and Filter
NOTE: Used hydraulic oil must be disposed of properly. Do
not pour it down a drain or sewer, or dump it on open land,

environment when disposing of used oil.

brake.
2.
switch.
Raise the seat forward to expose the hydraulic oil fill point.
Clean the area around the hydraulic fill oil cap.4.
Remove hydraulic fill oil cap.5.
6.
hydraulic reservoir and filter.
Remove the two bolts securing the hydraulic filter and 7.
allow the hydraulic oil to drain. Remove the drain plug from
the bottom of the hydraulic oil tank to drain. Replace the

8.
oil cap from hydraulic reservoir for faster drainage. Remove
nut caps and drain oil from both left and right pumps.

Remove the three screws from the top of the oil filter and 
replace the oil filter element. Coat the sealing surface

screws back into the oil filter.


Run and purge pumps and motors. Check oil level. 
 
NOTE: This tractor is equipped with two traction drive
pumps and one pump for steering and implement lift.
NOTE: After the tractor is up to operating temperature,
turn off engine and re-check hydraulic oil. If oil appears


Hydraulic
Oil Filter
Screw
Oil
Drain
Plug
Bolts
Figure 6-4
Hydraulic
Tank
Hydraulic Oil
Tank Cap
Hydraulic
Oil Filter
Hydraulic Oil
Fill Neck
Figure 6-3

Cub Cadet Tank S S7232D Specifications

General

Brand	Cub Cadet
Model	Tank S S7232D
Category	Lawn Mower
Language	English