INSTRUCTION SHEET
Instruction Sheet 8 of 8
DRM
If you feel that there is no difference, please contact us directly. We would like to speak to you about your feedback and
points of concern. Please send an email to ElectricRidingMowers@mtdproducts.com so that we can coordinate a time
to discuss this at your convenience.
17. Leave the left lap bar in the “OUTWARD”
position and move the right lap bar to the inward
“NEUTRAL” position as shown in Figure 12.
FIGURE 12
Left Lap Bar
Right Lap Bar Inward
“NEUTRAL” Position
“OUTWARD”
Position
18. For the completion of the right lap bar calibration,
repeat Steps 5 through 13, then proceed to
Step 19.
19. After performing the calibration procedures for both
lap bars, test drive the mower again in a large area
in both drive modes to verify that the recalibration
is satisfactory.
769-26105/01
To Previous Page
Loading...
